Updating firmware on dsr 4410md
STEP 6: Press and hold “Scan” button and connect the power back to the DNR-202L .The DNR will begin running thought it’s start up sequence, you will hear a long beep follow by a short one (continue holding the SCAN button) until the DNR-202L LED ring light will show a flashing red light, release the “Scan” button. STEP 7: After the firmware upgrade is done, the buzzer will give two short beeps this will marked the end of the upgrade process. Manually reboot the unit by disconnecting and reconnecting the power.- I have no existing RAID array group on card so if you have an existing raid array setup I don’t know if updating firmware on card will wipe arrays already setup. Download latest HP SSP (HPs Server Support Pack) from HP website I used the latest which at the time of writing is HP Service Pack for Proliant 2014.02.0-0_761723-001 spp_2014.02.0-SPP2014020.2014_0128.52.Use Unetbootin to unpack the ISO image onto USB drive I used 8GB San Disk stick 3. The HP SSP will now load, I picked Auto inventory option and update.The Motorola DSR-4410MD is a powerful digital headend product, capable of simultaneous decryption of up to 64 services.With advanced modulation support, the DSR-4410MD can output a full transport multiplex with both MPEG-2 and/or MPEG-4 services at an information rate of up to 160 Mbps.
I can't even get a backup of the configs because I get a "General Error" when trying to TFTP the configs in Pu TTY and when I try to view the Configuration Report in the web interface it just says Translator Failed.
If you have one of the them urgent reflash is recommended.